PACR NonPACR xfers via *8

[fesman]

I am trying to setup a vector which will allow incoming PACR calls via AT&T to be xfered out to a different center using a *8 transfer connect. I can get this to work via a VDN pointed to a vector that plays the *8 and correct transfer number digits. The problem I am having is that we also have non-PACR numbers that will need to be sent to the same xfer. I added in a route to number after the digits are played and ended up with 2 lines open to the number I am transferring to when calling on a PACR line. When calling on a non-PACR line I am bombarded by digits played in the announcement. Is there something I can add in the vector steps to alleviate these 2 situations? Here is the vector I have been working on:

1 wait-time 2 secs hearing silence
2 announcement 5188 (tones *8 800XXXXXXX *7)
3 wait-time 5 secs hearing silence
4 route-to number 9~p18886254988 with cov n if unconditionally
5 stop

 

[lopes1211]

Sounds like you need to use 2 vectors. Send the non-PACR VDN's to the route-to vector and the PACR VDN's to the annoucement/transfer vector.

-CL

 

[fesman]

I was hoping to avoid that as it will complicate things quite a bit; we have about 30 xfer numbers which would then turn into 60 and I would need to relabel 4,000+ VDNs with a disignation of PACR or Non-PACR as well as the training aspects of it.