We have a stack of G700s (3) in a remote location. We have configured ports 1/1 and 2/2 in a port redundancy configuration. Everything seemed to work well until last night or early this morning. When I dialed in to check the problem, I saw that both 1/1 and 2/2 were disabled. I just checked the stack last night everything was working fine. I did use the web interface to check to make sure the port redundancy was configured correctly, but I didn't change anything.
Does anyone know why two port would just disable themselves? These just happen to be the only to ports with live links to the network. They also happen to be the ports in the port redundancy config. I need to figure-out what happend to make sure that it does not happen again. Thanks
Does anyone know why two port would just disable themselves? These just happen to be the only to ports with live links to the network. They also happen to be the ports in the port redundancy config. I need to figure-out what happend to make sure that it does not happen again. Thanks