Operator extend call!

[rfpup]

Hello to all,

The situation is like this:

a. MD110 in site A is connected with MD110 in site B using H323 networking.
when operator at site B transfer the incoming call from PSTN to an extension in site A, this extension may transfer the call to another extension in site A.

b.MD110 in site A is connected with MD110 in site B using ISDN QSIG:
when operator at site B transfer the incoming call from PSTN to an extension in site A, this extension can not transfer the call to another extension in site A.


Two MDs are BC12 SP7

H323 route:

[tt]ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
100 7110000000000010 5 3110000001 0 30 128 03151515 011110000091 001100[/tt]

[tt]ROU TYPE VARC VARI VARO FILTER
100 TL65 H'00000111 H'00000011 H'00000000 NO [/tt]

Qsig route:

[tt]ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
110 7120000000000010 5 2110000001 0 30 128 00151515 111110000031 111100[/tt]

[tt]ROU TYPE VARC VARI VARO FILTER
110 SL60 H'00000310 H'05440000 H'06400000 NO[/tt]

 

[mundus]

a. MD110 in site A is connected with MD110 in site B using H323 networking.
b.MD110 in site A is connected with MD110 in site B using ISDN QSIG:

???????

Post the RODDI, maybe ADC d5=1 is missing.

 

[whosrdaddy]

in fact, situation b is correct and a is faulty.
this was identified as a bug, load latest SP (SP10) to correct this fault...

you never can extend operator calls (try this internallly)

However, I think changing the value of ASPAC 106 (TCM check) will allow transfer of networked operator calls.



-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[rfpup]

Thank you to all!

to Mundus:
I am still testing so you can see only QSIG route connected to DEST. IP route has the same parameters except CHO
[tt]<roddp:dest=10;EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
10 110 0626100000000050006000000 0 1 0 [/tt]

to Whosrdaddy:

I tried internally also but it do not function.
I tried like this:
an extension at site B calls to the operator of the site B and then the operator of the site B extend the call to an extension of the site A. This extension can not transfer this call to another extension in site A.
I also tried to aspacarnum=106,parval=1; but still no result internally.

So what can be solved if going to sp10?
Both internal and external extending will be successful?

Regards