We have two offices (S8700 at headquarters, tenant = 1, and G700s at the remote office, tenant = 2). Today each has their own operator attendant console, each receives their own 0 calls because of tenant partitioning. I've been asked to figure out a way for one operator to cover calls for another operator when she goes to lunch or on break, etc. Any ideas?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Operator consoles cross-coverage?
- Thread starter BHodgins
- Start date
- Thread starter
- #2
The whole point of tennant partitioning is to create two seperate phone systems. I don't personally know of a way to poke a hole through the partition.
The only thing I can THINK to try would be setup an IP Trunk between the two switches...
The only thing I can THINK to try would be setup an IP Trunk between the two switches...
- Thread starter
- #4
we have inter-office four digit dialing just fine using two tenant partitions ... is there a better way to set this up (take away tenant partitions?) ... they are in different time zones, etc., and so it's important that the phone clocks show local time, etc.
- Status
Similar threads
- Locked
- Question