Open Mobility configurator - IP DECT

[deltaserver403]

After open the OM configurator i can see some parameter,

put the mac address & fill the all the fields , we are not getting what to fill in the following filed.

Use_local_cfg.

when we left blank in this filed , after pressing the SEND button it says not valid .

Pls can some body help me

 

[intrigrant]

use the following parameters:

MAC Address = MAC Address of the basestation

use_local_config = 1
ip = fixed ip address of the basestation
subnet = subnet for the network
siaddr = ip address of the tftp server
boot_file = path and name of the boot file
usually something like ADMM_1_0_4.tftp
ommip1 = ip address of the master basestation, can be equal to "ip" if you are programming the master basestation

Once send the basestation has to be rebooted for changes take effect, make sure your tftp server is active otherwise you'll end up with a dead unit.
It can only be started if a tftp server is active!

Watch the LED on the unit, a red flashing LED means mo firmware loaded, the unit will search for a tftp server.
Orange blinking LED means the firmware is loading
Orange steady LED means the unit is starting
Green LED means that the unit has succesfully loaded the software and it is operational.
Connect to the master with Internet explorer 6+ using the ip address in the address bar :

http://<ip

address>
then the OMM Manager will be shown, login name = craft
login password = crftpw

Hope this helps!

 

[deltaserver403]

Thanks Intrigrant.

It is working fine now, but i am unable to see the configuration of IP DECT Line & IP DECT Extn using the Manager application.

Manager is 5.1(56).


Pls do the need full what version manager i need to use

 

[intrigrant]

Your Manager is OK.
The only reason i can think of wich disables the possibility to see the IP Dect line is that the unit is configured with the ENU locale.

 

[deltaserver403]

Thank you so much INTIGRANT,

It is working like a champ,

Thaks again

Regards
DS

 

[crashtest1000]

Have found a work around for the TFTP issue. Use a CF memory card or voice mail card. Load the ADMM tftp file onto this card and tell the RFPs that the IPO is the TFTP server.

This saves having to have a manger running and or a third part TFTP server.