??One system on a Novell and a NT neworks

[winkshog]

We are trying to speed up our network in one of our office.
we run on the state WAN 59k slo

http://wwwwwwwwwww.

but all ten of our offices are on this WAN. Now for some user we are able to plug into a 512k.

I have an e-mail server that is running GroupWise and the user are getting to that server through the client @IP 10.XX.XXX.XXX when I put the 2nd nic into the system To get speed internet for that user. the problem that i am having is that I have to set this up ever time the system is turned on. and I can only have one or the other not both networks.

Is there something is the novell client to let me do this?

How do I make this work. can I be pointed to the right Forum

Thanks for your help

Sean "Wink" Allen
DHD10
MIS LEAD

 

[Provogeek]

This is a TCP/IP routing issue and this should be posted in the TCP/IP forum.

The question is a bit confusing, I assume english is a second lagauage (not trying to insult you here, just an observation). Please try to clarify what it is your trying to do.

I think you are trying to install two network cards into each of your workstations so they can use a 59k WAN connection and a 512k Internet connection at the same time. The networks are seperated and do not share the same physical wire. I do not understand what you are "setting up" each time you boot the workstation. Is it the NIC driver? is the the IP address? Is it a routing table? The workstation can only access one network until you run through this setup you are doing each time.

For simplicity, you should have a router (can be a server) that is attached to both networks and routes traffic between the two.

=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+
Provogeek
CNE Network+ Experience

Certified nut case