(OLI) out going line ID is not working

[friendlyphoneguy]

I have a MICS 4.0 with a T-1 (not a PRI) under set programing I set the OLI to the same as the recieved digits on the target line. When I call my cell phone the display shows "call 1". The carrier is time warner they say their part is done. My T-1 is set up as T-1 E&M. have I missed something?

 

[hawks]

As far as I know OLI only works with a PRI or BRI circuit.

 

[gtechjoe]

I can only confirm that it works on a T1/PRI

 

[exsmogger]

To confirm Hawks and gtechjoe, OLI will only work on a PRI circuit, not a T1.

Brian Cox

http://www.jandjcommunications.com

 

[jerryreeve]

agree with the rest and in addition your telco has to allow the OLI digits to go out or the called party will see the MLN of the PRI

----------------------------
Hill?? What hill??
I didn't see any $%@#(*$ Hill!!
----------------------------
JerryReeve
Communication Systems Int'l
com-sys.com

 

[RikRodgers]

Why would Time Warner tell you "Their end is done"? As far as I know, OLI isn't an option with a straight T1, regardless of the platform. Sounds like they're a little confused.