I have a 2nd office which is just a few miles from my main office where I have my G3si. I'm looking for a cost efficient way to put 24-48 agents up in my 2nd office.
Anyone have any recommendations as to what the best way to do this is? I am running Multivantage 11 on G3si hardware.
Things that I've considered:
1. Point to Point T1, use 2 TN464F and a T1 channel bank at the other end, and just plunk in some analog sets.
2. Point to point T1, save as above, but instead of a channel bank, connect it to some small PBX or Key system that can have each station pick up a single channel.
I'm concerned if I put in IP agents that it may be costly and the line quality may be not as good.
Also to note, I dont need control of the phone, we have CTI apps that can control the phone, so really all I need is a good path for the voice.
Any other suggestions or anyone have any experience with the 2 suggestions I have?
Anyone have any recommendations as to what the best way to do this is? I am running Multivantage 11 on G3si hardware.
Things that I've considered:
1. Point to Point T1, use 2 TN464F and a T1 channel bank at the other end, and just plunk in some analog sets.
2. Point to point T1, save as above, but instead of a channel bank, connect it to some small PBX or Key system that can have each station pick up a single channel.
I'm concerned if I put in IP agents that it may be costly and the line quality may be not as good.
Also to note, I dont need control of the phone, we have CTI apps that can control the phone, so really all I need is a good path for the voice.
Any other suggestions or anyone have any experience with the 2 suggestions I have?