Nortel MICS lost power now FUNKY

[kflounders]

MICS with NAM, six port Fiber, 2-16s, 2-analog 8s, and a trunk 12. The system lost power over the weekend and would not come up after several reboots. I removed all of the cards in the MICS(Fiber and 2 Trunk-4s)and the system will come up for the operator phone, while all others are "In Maintenance" due to the removed cards. I cannot get the system to come up with any of the cards plugged back in.

Each time I plug any of the cards and reboot the system just cycles for at least 15 minutes. When the cards are out the operator phone will appear to work and has the correct programming on the buttons and extension names.

When the system is up it gives me "IN Use Mega-sr" when I try to go into CONFIG.

I have another MICS on the way and hopefully it will fx the issue, but I wanted to see if I was missing anything stupid.

Kevin Flounders

http://www.comstar-usa.com

 

[hawks]

The MEGA message is because it is looking for the 2 6 port fiber cards. Maybe 1 of those went bad.

 

[kflounders]

When it says that I have the fiber mod removed, so that makes sense.

Kevin Flounders

http://www.comstar-usa.com

 

[exsmogger]

If there's only one 6-port fiber, are you installing it in slot 2?

Brian Cox
Oregon Phone

http://www.OregonPhone.com

http://www.linkedin.com/in/briancox1952

 

[kflounders]

Just one Fiber, in slot 1 (on the Right). I gave up and just threw a new MICS in. It resolved the issues, but now I cannot transfer callers to people and have them go to VM. I am going to open a new thread about this.

Kevin Flounders

http://www.comstar-usa.com