We have been using a CSE1000 to a Verizon switch over 2 PRI lines with NI2. We have been attempting to switch to Level 3 as our phone service provider over the same PRI lines. The Verizon switch is set up for Centrex so the only other thing we had to do was to remove the "9" insertion. We were unable to dial out with 7 digit dialing. We could only dial out with 11 digits 1npa-nxx-xxxx. This was with the Level 3 switch set to NI-2. When we changed to NI-1 we were able to fully dial out with no problems. the problem is we need NI-2 to have incoming CallerID NAME. The CSE 1000 shows LOCL when we do 7 digits, but the Level3 DMS 500 on monitor shows NATIONAL. Unfortunately there was no FireBird or such monitor to see what was really on the PRI line. Has anyone seen this problem before.
Thanks,
Larry Avrunin
Thanks,
Larry Avrunin
