Nokia Voyager Apache access problem

[jamesworthy88]

I have a Nokia IP330 (ipso 3.3) and ran thru the initial install. However after entering the hostname, ip address, netmask, etc. I cannot connect via Voyager but I can ping the interface successfully. I also tried using lynx over the console but I get the following error: 'can't access startfile

http://localhost'.

I've deleted the config/active file and reinstalled a couple times to make sure I didn't enter anything invalid but same problem. The hosts file has an entry for localhost with ip address 127.0.0.1 but I received the same error whether using localhost or ip address. I also trid using telnet on port 80 and I don't even get connected so it's more than just apache missing a default page. Since it's a new install Checkpoint isn't running and blocking any traffic either.

Can anyone tell me how to verify that apache is up, running and listening on port 80? Other suggestions/ideas?

 

[jamesworthy88]

I figured this out and thought I'd update in case anyone else ever runs into the problem.

The apachectl script which starts httpd (the web server) had the user

http://www tied

to it. However that user must have been deleted. I recreated the

http://www user

account with the ipso dbset command and only then was able to successfuly start the apache daemon. Afterwards, I was able to use Voyager.