NO ANSWER from GAR

[CIF]

Hi everyone,

I want to restart a gjgug board and I try to block it first.
While executing GJBLI:GSMULT=1-12,GSSIDE=0;
I get the following message: No ANSWER FROM GAR;

Anyone????

The problem is that i have a LIM out of order.

grttz Cif.

 

[dstrang1]

You're getting that response precisely because there is no contact with that LIM. First block the remaining links on that GJU-G board and then re-seat it in the magazine. If that doesn't restore contact you'll then need to verify continuity along the entire transmission path between the LIM and the GS.

Good luck,

Dave Strang

 

[md110user]

Dear Sir

How can I end this link or change the position GSMULT=0-7 I want to change it to Position 0-25 because the PINS on the Bakplane of GroupSwitch Magazine is broken on that posiotion.

When I want to blook then end I receive a message:
No ANSWER FROM GAR

How can I change the position???

Regards

MD110USER

 

[dstrang1]

Dear Sir

MD110USER axed:

>How can I end this link or change the position GSMULT=0-7 >I want to change it to Position 0-25 because the PINS on >the Bakplane of GroupSwitch Magazine is broken on that >posiotion.

>When I want to blook then end I receive a message:
>No ANSWER FROM GAR

>How can I change the position???

>Regards

>MD110USER

You don't have to block a PCM link to end it. As long as there is another link in that LIM, you should be able to end 0-7 and initiate 0-25.

Otherwise you'd better start looking for a replacement GS mag.

Good luck,

Dave Strang

 

[alexa01]

I have two LIM sistem without GSM.
Between LIM1 and LIM2 is one PCM link. I decide to erase LIM2. ALEX documentation for LIM erasing is OK, but, when I erase LIM 2, I
still have a PCM link and GJUL in LIM1.
on CNBOE I get "INDIVIDUAL IS STILL INITIATED ON 1-0-00-16"
on GJBLI I get "NO ANSWER from GAR"
How can I erase PCM link and GJUL in LIM 1???
Regards

alexa01

 

[dstrang1]

alexa01 (Programmer) 1 Aug 06 10:49 sed:

>I have two LIM sistem without GSM.
>Between LIM1 and LIM2 is one PCM link. I decide to erase >LIM2. ALEX documentation for LIM erasing is OK, but, when >I erase LIM 2, I
>still have a PCM link and GJUL in LIM1.
>on CNBOE I get "INDIVIDUAL IS STILL INITIATED ON 1-0-00-16"
>on GJBLI I get "NO ANSWER from GAR"
>How can I erase PCM link and GJUL in LIM 1???
>Regards

>alexa01

Don't try to block it first.....just end it. GJLIE:GSMULT=X-X;
Then you can send CNBOE:BPOS=1-X-XX;

Good luck,

Dave Strang