New IP phones (i1120E, 1140E, 1150E)

[riteeh]

Hello,

I have been read on here that when adding an 1140E phone into a PBX it is setup as an i2004 in LD 11. Because of this I assume the TNB printouts will be identical for an i2004 and i1140E. Is this the case or is there any way to tell the difference between an i2004 and an i1140E in the TNB printout of the set in LD 11?

Thanks in advance for any replies.

 

[jamming1]

Not under the current releases. That will change in the next release of software.

 

[riteeh]

Thanks for the reply.

 

[jamming1]

I forgot about this command. Its not the LST in ld 83 but it might get you what you need.

Ld 117
=>stip modl 1120E

This will give you the IP address and more of all your 1120.

You can change the phone type with any other IP phone (1140E, i2007). I haven't tried it with WLAN phones.

Also if you go under ld 117 and type in ? and enter look under the commands STIP. Lots of diffrent ways of to look up phones and IP addresses. I use STIP TN then just type in the Virtual Loop and it will list everything in that is in that Virtual Loop.