New Cisco 2801 with VWIC - Need it to act as a CSU

[Rookcr]

Good morning,

I have new Cisco 2801 ISR's. I currently have older 2500 routers and that is my config expierience. I have seperate CSU/DSU units connected to serial interfaces.

On this new router I have a VWIC that is installed. If I do a show config I recieve the following:

controller T1 0/1/0
framing esf
linecode b8zs

I would like this to be my CSU/DSU and I dont have the configs I am used to. I need to assign the IP address for my WAN. On my old 2500 routers I have the following:

interface Serial0
no ip address
encapsulation frame-relay IETF
no fair-queue
frame-relay lmi-type ansi
!
interface Serial0.1 point-to-point
ip address x.x.x.x 255.255.255.0
frame-relay interface-dlci 16
!

I need to know how to do this on the VWIC.

Thanks

 

[JOAMON]

What model wic in each router.

 

[Rookcr]

My router is a 2801

The VWIC is :

VWIC-1MFT-1T

 

[JOAMON]

Not familiar with that but you might take a look at the following and see if it may help:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120t/120t7/t1_mf_t6.htm

 

[Rookcr]

I think I had just found this article. I am now trying to figure out what it means. thanks!