Netware alert message

[Jo28]

I am getting a Alert message when I load the CE1000.lan. The message isn't an error message it just says that the link is up and okay. I was hoping that there would be a way to get rid of that message without having to hit CTRL + ENTER, since I was hoping for my boot disk to be fully automated. Any help would be appreciated.

Thanks,
Jo

 

[marvhuffaker]

Are you talking about a boot disk for a client workstation?

Marvin Huffaker MCNE, CNE
Marvin Huffaker Consulting

http://www.redjuju.com

 

[Jo28]

Yes, It's a boot disk that I use to load PC Images from our network and dump them on the client workstation. Now we have a few that are ordering DELL pc's and when I load the driver it gives me that alert message saying it loaded it. But then it needs users intervention to keep going! I need a way to disable or get rid of that box! ANyways ideas?

Jo

 

[marvhuffaker]

Yes, I have some ideas but it's been a looooooong time since I've dealt with DOS clients in a production environment.

If i recall correctly, you get a popup when you try to load a second instance of a driver. for example, once for IPX and once for IP..

Is this the case? If so, you have to put []'s around certain parts of the load line to avoid this. I just cant remember the exact syntax but it may point you in the right direction. I believe the []'s go around the INT and PORT --OR-- the SLOT parameters..



Marvin Huffaker MCNE, CNE
Marvin Huffaker Consulting

http://www.redjuju.com