Need help finding some Converse-on command information.

[DAVIDPAYNE]

I am looking for some information.
When using the Converse-on command, How much of a time delay is there between when the data is sent and when the # sign is sent?

Any information would be helpful.
Thanks
David

 

[BIS]

Look at page 8 of 'disp sys feat'. In the vectoring section...

 

[BIS]

Look at page 8 of 'disp sys feat'. In the vectoring section...

 

[DAVIDPAYNE]

I have looked at page 8 of the Feature-Related System Parameters screen. I see the delay information for the 1st data, and the second data. But What I need to know is how much delay is there between the data, and the # sign, which is the end of the data marks. Is that the Converse Signaling Tone, or Pause timers?

Thanks
David

 

[europe]

The Connverse Signaling Tone (msec) states how lang the Definity will send a tone, The Pause (msec) states how long the pause between two tones lasts:

In effect:

<tone><pause><tone><pause><#> Please let me know if the information that was provided is helpfull.
Edwin Plat
A.K.A. Europe