Need help configuring BE 10.0 to removable disk product

[willjwill]

I am using BE 10.0 and backing up to an appliance that uses disks as both a fixed target as well as removable media. Does anybody have any suggestions on how to configure these jobs to span disks from removable disk D to removable disk E? I currently have a 400GB drive in D and a 300GB drive in E and my job is about 600GB. I think there is a way to set a drive pool but I am not sure where to find it.

Thanks,
John

 

[justin2000]

You can't setup a cascaded drive pool with B2D devices.

The only thing that you can do is either combine the drives in Windows somehow - change them to dynamic and then stripe them - this will give you 1 drive letter - don't even know if you can do this with removable harddrives - most probably not.

You could also split your backup to go to each disk.