Need Ac code to register gdc-345h

[LEEGARTH]

Hi i am trying to register a gdc-345h lg handset to our LDK-24 nexar phone system
i have managed to unregister an old handset but when i try and register the new one it finds the system and then asks for a AC code???
Any help would be greatly appreciated

Regards

 

[doktor]

There is no AC code needed for DECT registering, unless it has been programmed in from the operator terminal.
You can set a new AC code (e.g. 1234) from the operators console by:

TRANS/PROG + 0 # + BUTTON 3 + "1234" (AC kode) + HOLD/SAVE.

Do not do this if you have other handsets working.


///doktor

 

[doktor]

If you use
TRANS/PROG + 0 # + BUTTON X + HOLD/SAVE.
Try with button X= 1+2+4+5+7+8.

The button are the flex buttons on e.g. a LKD-30, where you have 10 rows of 3 flex buttons in each row.
They are numbered:
1+2+3
4+5+6
7+8+9
etc..

One of these will give you the AC code.

Button 3 and 6 should not be checked. If you check these, make sure not to change anything.


///doktor

 

[LEEGARTH]

Thank you works a treat