Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

NEC IPK

Status
Not open for further replies.
dramis1

dramis1

Technical User
Joined
Jul 13, 2009
Messages
1
Location
CA
I'm trying to program a 6th CO line on an IPK. According to system programming, line key 6 is programmed for CO Line 6, however when I do a status on the sets buttons the 6th line key displays "unused".

Any suggestions would be greatly appreciated

Maurice
 
Sort by date Sort by votes
Verify the telephone port. Press FNC (Feature) then 4 on the dial pad. Read the display for the port number vs extension number. The key data is programmed to the telephone port number in CMD 4-12. Also, in CMD 4-12 for LK 6 make sure is says CO 06 and line ket 2 is lit. You may have assigned it as a CAP key c006 and not CO 06.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

R
  • Locked
  • Question Question
NEC IPK-I
Replies
1
Views
599
dmanghani
dmanghani
AdanPMtz01
  • Locked
  • Question Question
NEC Electra Elite IPK Single Line burst dial tone reset
Replies
2
Views
473
george3283
george3283
R
  • Locked
  • Question Question
Upgrade Path for NEC IPK to SV8100, SV9100 ?
Replies
7
Views
1K
CoralTech
CoralTech
R
  • Locked
  • Question Question
NEC IPK-I Moving from T1 to PRI
Replies
7
Views
1K
RuralHospital
R
B
  • Question Question
NEC Standard SIP
Replies
9
Views
776
Rafi415
R

Part and Inventory Search

Sponsor

Back
Top