Name display problem-NRS

[kondalisa]

Hi, i have setup NRS and a CS1k rls 5 system is tied with BCM400 rls 4 using SIP. The problem is that the name display of extension is not displaying on both system extension when they dial each other only Hxxx where xxx is extension number, DChannel is set with IFC=SL1/RCAP=ND3 with no rls ID (i just entered on RLS prompt but it shows 25 int print out of DChannel) and at BCM protocol is SL1.
I made CDP as dialing plan.
Any help in this??

 

[johnpoole]

mine works but i'm using qsig tdm... but you need to trac the calls from your ext to be sure your sending.. mon the d if you can with sip.. that will tell you that your sending and cisco is ignoring.. or just the opposite.. if you mark the routes internal, rcap nd3, names will be sent

john poole
bellsouth business
columbia,sc

 

[Avaya911PLM]

Works fine on my lab system 5.50 and BCM 50 R3 with SIP and H.323

--
Fletch

Nortel Emergency Services PLM

http://nortel.com/e911

Check out this month's E911 Talk podcast at Nortel E911 Talk Podcast

 

[kondalisa]

Hi Fletch can you help what you set at IFC/RCAP/RLS at you dchannel and at BCM protocol settings i mean CSE or SL1?

I am still not getting name.
Regards

 

[Avaya911PLM]

CS 1000 Side:

ADAN     DCH 100
  CTYP DCIP
  DES  IP_DCH
  USR  ISLD
  ISLM 4000
  SSRC 1800
  OTBF 32
  NASA NO
  IFC  SL1
  CNEG 1
  RLS  ID  3
  RCAP ND3
  MBGA NO
  H323
    OVLR NO
    OVLS NO

On the BCM Side it is set to CSE



--
Fletch

Nortel Emergency Services PLM

http://nortel.com/e911

Check out this month's E911 Talk podcast at Nortel E911 Talk Podcast