Have a NAM that stopped working. F9xx doesn't work. Tried reboot but doesn't go thru proper startup sequence. Digital display shows 7C I believe (not sure what it means). Is it safe to say it's done for? I know Nortel MD'd & no longer supports this product and replaced it w/ CP 150.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
NAM
- Thread starter Onyx1
- Start date
lugerlover
Programmer
try reseating all boards and blowin out the dust bunnys while in there
- Thread starter
- #3
lugerlover
Programmer
yes there are ..open front of blue box and reseat iether fiber or copper card and any other card in there..resat ribbon cable to hard drive...make sure if there are jumpers that they are still seated....unless you are talking about a flash...bust a flash has no display...
- Thread starter
- #5
lugerlover
Programmer
7a and 7f point to hard drive...what was the tone sequence on boot
Try adding an ISA video board to watch the bootup sequence. It does sound like a hard drive problem.
Brian Cox
Brian Cox
- Thread starter
- #8
- Status
