MXE unable to do a manual install

[mitelsx2k]

Hi Guys

I need to upgrade a mxe controller to mcd 6.0 and i keep getting an error after setting the normal settings for a manual install as below

auto-booting...


boot device : motfcc
unit number : 0
processor number : 0
file name : Boot_Install
inet on ethernet (e) : 10.0.0.2:ffffff00
host inet (h) : 10.0.0.10
user (u) : ftp
ftp password (pw) : ftp
flags (f) : 0x0
other (o) : motfcc

Attached TCP/IP interface to motfcc0.
Attaching network interface lo0... done.
Loading... timeout - retry
Loading...
Error loading file: errno = 0x3c.
Can't load boot file!!


any ideas cheers

 

[kwbMitel]

Is your FYP server setup correctly at 10.0.0.10?

**********************************************
What's most important is that you realise ... There is no spoon.

 

[mitelsx2k]

Yes it is but when i try and browse to the ftp.10.0.0.10 i would expect to see the mcd 6.0 sw but i just get the page cannot be displayed.

 

[kwbMitel]

try it from a dos prompt

If you can't see it, the phone system sure can't

**********************************************
What's most important is that you realise ... There is no spoon.

 

[sarond]

make sure the root directory of user 'ftp' is where the software is.

What FTP Server are you using? Can you look at the logs to see if there is a connection being made.

 

[LoopyLou]

Think everyone is pointing you in the right direction i.e its your FTP server that can't be seen from the controller. Where are you doing an upgrade from? Attached to the controller or somewhere in the network? As others have pointed out you need to define the home directry for the FTP server and put the software there. Test from the command prompt to yourself and make sure your user name and password work for the FTP access. Temp turn off any firewalls or create an exception.

An apple a day keeps the doctor away. Anyone else and you need to throw it harder.