Multiple calls on a target line when only one line appearance

[wcteltech]

Is it possible to receive multiple target line calls on a set if you only have one line appearance assigned? I tested and expected the 2nd call to come through the intercom path. It didn't and rang to the prime set of 221. I remove the prime set from the target and the PRI channels and got silence from the phone I made a second call from. The system is MICS 6.0 with a PRI.

I thought this had worked for me in the past.

 

[PERRYPJ]

If you have 2 intercoms on the phone just flag the target line to ring, then you will receive 2 calls. if you flag it to appear and ring you only get one call

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[wcteltech]

I have 5 Intercom keys on two sets that have the some target programmed to ring. I tried just ring only for both and when the one phone was busy after it received a call from the DID a second call would came in and would ring only on the second phone programmed with that DID. I want the busy set to receive a second, third,,,call.

 

[cook1082]

Go to the target line section and change the prime line to the assigned extensions DN. Then it will ring on second,3rd 4th 5th call to the IC'S.

 

[wcteltech]

Yes, that works for one of the programmed ringing sets but not the other. This site has two reception sets and i am trying to make them behave the same way.

 

[atcom]

It's very simple - go to the line under Line Assignment where it says Ring Only and press show. You can change the number of "appearances" there.

-----------------------------------
Telephone & computer wiring/Cat 5E/Cat 6/Fibre Optic cabling in Calgary, AB

 

[ironhorse17]

Make a pick up group for the 2 extensions.

One extension with the prime line for those lines and the other with a pick up key for that group.

The second extension would need to hear the first extension.

Maybe an answer dn key on the second extension from the first extension.

 

[fonegal]

Hey,this is an easy one.Go under line appearance for that set and when it shows that target line as appear and ring hit the show button and change it to how many appearances you want and do it to both phones,Also make sure you have the main set as the prime set for that line!!!That should do it