Hi,
I've a big problem. The configuration is 3 Stacks, one with a BPS2000, 5 Baystack450T, one with 5Baystack 450T and 1 with 4 Baystack 450T. SW is 3.1.0.22 and FW 1.47 on the last two stacks and the BPS is FW:V0.36 SW:v1.0.0.81.
The 3 stacks are connected to an accelar 1150 (each port 1Gb, one stack with two lines, MLT).
Now we wanted to run a multicast application like Imagecast. It says disable IGMP snooping and enable IGMP Proxy. On the stacks i can only enable or disable both of them.
If I disable both of them the stacks can't communicate correctly with eachother. Some clients can connect, some not, if i go to the mac address table the console hangs.
Also ist it normal that in the port configuration Stack and switch autonegotiate to 10mbit/half? I've set i now to 100mbit full. Seems to work better ;-)
Should I update to new SW? Some other solutions?
Greetings,
Dirk.
I've a big problem. The configuration is 3 Stacks, one with a BPS2000, 5 Baystack450T, one with 5Baystack 450T and 1 with 4 Baystack 450T. SW is 3.1.0.22 and FW 1.47 on the last two stacks and the BPS is FW:V0.36 SW:v1.0.0.81.
The 3 stacks are connected to an accelar 1150 (each port 1Gb, one stack with two lines, MLT).
Now we wanted to run a multicast application like Imagecast. It says disable IGMP snooping and enable IGMP Proxy. On the stacks i can only enable or disable both of them.
If I disable both of them the stacks can't communicate correctly with eachother. Some clients can connect, some not, if i go to the mac address table the console hangs.
Also ist it normal that in the port configuration Stack and switch autonegotiate to 10mbit/half? I've set i now to 100mbit full. Seems to work better ;-)
Should I update to new SW? Some other solutions?
Greetings,
Dirk.