Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

mrtg and snmp

Status
Not open for further replies.
ilpadrino

ilpadrino

MIS
Joined
Feb 14, 2001
Messages
416
Location
US
Hi. I'm trying to setup mrtg. I have enabled the RO community string for snmp on the cisco router i want to test with. I still get all those errors from rateup about the primary log file. And yes, I've run it about 50 times.

My question is do I need to have logging enabled on the router? Right now when I type "show snmp" it says logging: disabled. How would I enable it? If not, what else should I look at as a problem?

I'm using my workstation with XP to run mrtg.

thanks in advance, joe.
 
Status
Not open for further replies.

Similar threads

CPM86
  • Locked
  • Question Question
Cisco isr 4331 with IOS and sip busy fail over to 2nd sip number on pbx?
Replies
0
Views
572
CPM86
CPM86
dogg1
  • Locked
  • Question Question
CUCM SNMP Set Command
Replies
1
Views
681
whykap
whykap
Lccarter
  • Locked
  • Question Question
Cisco CUCM Provisioning and Order Management System
Replies
1
Views
475
Lccarter
Lccarter
acabezas2014
  • Locked
  • Question Question
Need to create QoS for SNMP and Radius traffic on Cisco 4948 Switches
Replies
0
Views
309
acabezas2014
acabezas2014
mrdom
  • Locked
  • Question Question
RV325: Accessing LAN and WAN resources using the same hostname ...
Replies
0
Views
328
mrdom
mrdom

Part and Inventory Search

Sponsor

Back
Top