GettingIPO
IS-IT--Management
Please save my life.
I have an IPO 406 V2 with 2 x Quad Bri cards and a modem 12 card installed. This box is being used as a RAS Box.
ISDN dial in works a treat, but when dialing in from an analogue modem, a cause 17:user busy message is displayed in the monitor, and an engaged tone is received on the external modem.
A incoming call route has been setup that routes everything to DialIn, and the bearer type set to anyvoice, as detailed in document cd for analogue use.
Another incoming call route was setup with a specific DDI number that routes the same as above.
No matter what you do, it is the same thing, if you however route the call to an extension it works, extension rings and everything is happy
I have an IPO 406 V2 with 2 x Quad Bri cards and a modem 12 card installed. This box is being used as a RAS Box.
ISDN dial in works a treat, but when dialing in from an analogue modem, a cause 17:user busy message is displayed in the monitor, and an engaged tone is received on the external modem.
A incoming call route has been setup that routes everything to DialIn, and the bearer type set to anyvoice, as detailed in document cd for analogue use.
Another incoming call route was setup with a specific DDI number that routes the same as above.
No matter what you do, it is the same thing, if you however route the call to an extension it works, extension rings and everything is happy