MIRAN2 passtrough on OPT11c 1

[geirendre]

Hi.
Just wanted to know if it's possible to set up
a passtrough way in to the MIRAN2.
So I can use the AX-function to access MIRAN
just like with the MerMail.
And can it be done without connecting the MIRAN serial-cabel
to a TTY-port?

Thanks

 

[morenot]

yes,
Check ld 22...ADAN if you have TTY 3 like LSL
If yes, Just type at prom> ax 3 cr cr, to return: CTRL ]
If not, see below:

Option 11C CEMUX/pass-thru access configuration
Prompt Response Description
REQ CHG Change data
TYPE CFN Configuration record
ADAN NEW TTY 3 Add new TTY
TTY_TYPE LSL Low speed AUX link
CAB 0 Main cabinet
CNDO 03 Card slot
PORT 0 MIRAN port
DES MIRAN Port or link designation
FLOWTYPE NONE Flow control
BPS 9600 TTY speed
BITL 8 Number of bits
STOP 1 Stop bit
PARITY NONE Parity bit
ENL Enable MIRAN
Note: To access the MIRAN, type the prompt ‘AX<space>[port number]. Press Enter twice to display the MIRAN OA&M screen on the maintenance terminal.
To return to the system TTY mode, type <CTRL>] and the control will be passed back to the Meridian 1 system.

 

[MagnaRGP]

Would this work on an ITG, VGMC or Voice Services card as well?

 

[geirendre]

Thanks morenot worked for me

 

[Firebird Scrambler]

Does this method also work on the Miran 3 card?. I've got one in slot 2 on a 4.5w 1000M system. I can't get it to work via AX or even AX 6 (6 = the ADAN TTY port used). My guess is that Nortel was now using the Browser function instead.

All the best

Firebird Scrambler
Meridian Programmer in the UK

http://mysite.orange.co.uk/firebird_scrambler

Useful Nortel forum at

http://www.tspforum.com

If it's working, then leave it alone!.