MICS PRI CLID

[stsironr]

Is it possible to program different out-dial CLID depending on the group. IE: Customer has 2 companies using the same PRI. Group 1 would like the CLID to show NPA-NXX-2000 and group 2 NPA-NXX-4000. I know this can be done on an Opt.11C PBX is possible on the MICS?

 

[luv2ski]

as long as telco lets ya you can have each set display what ever you need displayed...but telco must permit the outgoing clid

6 months until ski season starts...sadly i must resign myself to the warmer weather"this will include a normal 8-5 work day, 5 days a week"

 

[senk1s]

there is no grouping - it has to be programmed individually

like luv2ski said, the telco must allow it as well

 

[gecko202002]

You should be able to setup an OLI# on a set per set basis. Although only 1 number per extension. Most PRI's accept this information.

 

[MarvO1]

All answers above are correct. I am in the middle of an installation right now that is 3 companies on one system.
Telco agreed to insert company X name from any set that we sent xxx-xxx-xxxx as an OLI, company Y name for yyy-yyy-yyyy, and company Z name for zzz-zzz-zzzz. It's just a matter of discussing what you need with your PRI provider. I have had very good luck getting what I need from them.

MarvO said it