Installed an MICS 7.0 from new this week. When it came up in default as new, for each phone the paging zone was set to zero and the "change" soft key wouldn't move any set to another paging zone. Paging works if 'all zones' is selected. This has not happened on any other 7.0 I've done. Any ideas?
Hoping this is not a "New for Norstar" feature....
... interesting note on using a hunt group as a call DN for the door phone with distinctive ring. Worked darned fine. Had this set up (less distinctive ring)fail on a 4.1. Luck customer doesn't want a page at the end of the ring cycle with the above problem on their system.
Cheers
PhM
VVV
Hoping this is not a "New for Norstar" feature....
... interesting note on using a hunt group as a call DN for the door phone with distinctive ring. Worked darned fine. Had this set up (less distinctive ring)fail on a 4.1. Luck customer doesn't want a page at the end of the ring cycle with the above problem on their system.
Cheers
PhM
VVV
