MICS 6.1 Expansion Question

[ahallai44]

Customer is maxed out with 8 incoming phone lines. I just installed 2 port fiber expansion card and fiber trunk module with a new loop start card in the fiber trunk module. My question is where do these new lines appear on the 66 block?????? This will be the ninth line on the system.

 

[DigitelD]

You would terminate the amphenol cable from the 12X0 module on the 66 block.
1st card:
w/bl pr=line 9
w/or pr=line 10
wh/grn=skip
wh/brn=skip
wh/sl=line 11
r/bl=line 12
r/or=skip
r/grn=skip
r/brn=line 13
r/sl=line 14
You would continue the sequence of line,line,skip,skip and so on. The module is capable of 12 lines.

SHK Certified (School of Hard Knocks)

 

[exsmogger]

Be sure to connect the trunk module to the topmost fiber expansion port.

Brian Cox

http://www.jandjcommunications.com

 

[ahallai44]

Ok then I think I messed up. I only have in my possession the 2-port fiber card which is located inside the MICS cabinet. The fiber jumper cord is going to the new fiber expansion trunk module. Is there a amphenol cable output off of this trunk module somewhere?

 

[exsmogger]

Just open the door on the trunk module. You can't miss it.

Brian Cox

http://www.jandjcommunications.com

 

[lugerlover]

my guess would be if you did not know where the amp went then you better make sure you have a analog trunk cartridge

 

[ahallai44]

Well I really feel like an idiot now. I just went back to the customer site yesterday and opened the door and there was the amphenol hook up just like you all said. If it was a snake would of bit me. Thanks all.