MICS 6.0 External Transfer

[Tech9]

What is the best way to set up call transfer between two MICS 6.0 Norstar's using analog E&M tie lines. The customer wants to by able to transfer the call's to individual extensions on the remote system across the tie lines.

Thanks for your help in advance.

Tech9

 

[Roldan]

First, you need to setup destination codes on your MICS of the extensions of the remote site. Second, you need to build routes for these destination codes so that when these extensions are dialed the MICS will know to access the E&M lines to make the call. Once this is set up, all you have to do is press transfer then dial remote extension number and at this point it's just like an internal transfer. With all this said, if you can already dial directly to remote site by just dialing the extension number then it sounds like this is already setup for you. I hope this helps you out, Good Luck!