Mics 5.0 with Pri ,No caller Id

[fonegal]

Upgraded my 5.0 Mics to a Pri from a T-1 today but do not see any option in terminals and sets to set caller id for the target lines on each set that appear and ring.Was caller id not available on 5.0 with Pri?

 

[norstarboy125]

Show a target line i.e. 157 and you will see CLID set, Prime set etc. On pre 6.1 software for a MICS you can only have 1 target line auto info clid. If your using DID's which I'm sure you are then every set will have it's own target line and will have clid abilities. If your using the same target line for multiple sets then only 1 will display it while ringing, the rest can use f 811 or just wait until you pick up the handset to see it.

Jeremy J. Carter
Charm City Communications

http://www.charmcitycommunications.com

Norstar. BCM. CS1000 Programmer

 

[fonegal]

Thanks Norstarboy I forgot to look under target lines I only looked under terminals and sets.

 

[norstarboy125]

No problem, you will see it under line programming for sure.

Jeremy J. Carter
Charm City Communications

http://www.charmcitycommunications.com

Norstar. BCM. CS1000 Programmer