Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

MG1010 - MGU

Status
Not open for further replies.
chrisay59

chrisay59

Technical User
Joined
Jan 20, 2005
Messages
156
Location
GB
Hi Guys, I was wondering if anyone else out there has had an issue with the MGU on MG1010 blowing componants, namely C12, C13 and/or L1 on the PCB. I have had three in the last 7 days!
 
Sort by date Sort by votes
Hi,

I have also seen this issue, exactly the components you mentioned.
have you found any response or way to fix without replacement?

cheers
 
Upvote 0 Downvote
Hello folks,

there is a known issue on that, fuse “F4” has to have a value of 5 Ampere instead of 3 Ampere, you can see that on the new cards they are labeled Rel.: 5, tis are the good ones.We had a lot of them in the feeld and we are replacing them

regards
Fritz
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

SherWat
  • Locked
  • Question Question
Differences between MG1010 and MG1000 Chassis
Replies
2
Views
438
bignose21
bignose21
lapakhora
  • Locked
  • Question Question
MGU card LED Indications problem
Replies
3
Views
328
janaya
janaya
motox2
  • Locked
  • Question Question
MGU to serial pinout
Replies
1
Views
225
bignose21
bignose21
routetehpacketz
  • Locked
  • Question Question
Moving cards from Opt11C to MG1010 - is this possible?
Replies
2
Views
245
KCFLHRC
KCFLHRC
pbxgirltech
  • Locked
  • Question Question
CS1000E MG1010 Bayface
Replies
2
Views
260
pbxgirltech
pbxgirltech

Part and Inventory Search

Sponsor

Back
Top