Meridian CAP

[dosjock]

Trying to install a cap unit on a M7324 set. Have 24v, polarity is correct. Phone and cap both boot up. I can see sets that are in use light up on the cap unit, I just can't get to the cap to program the buttons. SW ver 30EBF07. System has a second cap unit, on that one I can do a button inquiry, F*0, and program buttons, F*1, F*2, F*3, seems like the system dosen't see the second unit. I seem to remember on the MICS, under sets, you had to tell system there was a cap on a 7324 set. I can't find that option on the meridian. Anyone have any suggestions?

Thanks

 

[HASAGO]

Might pay to start a forum in the Norstar area as this is the Nortel Meridian PABX forum. You might get a better response from there.

 

[dosjock]

Thanks, I'll repost there