Member already exists in a object module.

[wjmontague]

The expression On Dbl Click you entered as the event property setting produced the following error: Member already exists in a object module from which this object module derives.

I know the dbl click procedure was working for employee names, manufactures, and assests. Where is you double click on the field you can add to the Combo Box a new entry. Suddenly I get the above error on all three combo boxes. Any ideas? Thanks Warren

 

[wjmontague]

I found the answer myself. It was a syntax error in one of my double click event procedures. The name of the procedure at the top did not match the name at the bottom of the procedure. This affected all of my double click procedures while the error was only in one of the twenty or so for that form. I found it by erasing half of the procedures at once, then half of the ones that caused it etc until I narrowed it to the one offensive procedure.