MEDPRO ports

[zreal1976]

Ls.

Does anyone knows why I can not use all my medpro ports.
If I do a list config i will see the following:

01D13 IP MEDIA PROCESSOR TN2302AP HW18 FW118 01 03 05 07

IF am correct it should show all ports (1 to 8)

Who knows what I am missing in my config?

 

[Samanody]

Please check: status media-processor board
what it will show u????
Its not related to ur programming...

 

[zreal1976]

When i do a satus media-processor I will get the following :


MEDIA-PROCESSOR STATUS

Board Loc Code Vintage
01D13 TN2302AP HW18 FW118
Ethernet Enabled? yes Node Name: MEDPRO
IP Address/Mask: 192.168.2.15/255.255.255.0
Gateway Address: 192.168.2.253
MAC Address: 00:04:0d:51:00:00
Link Status: connected Network Region: 5
Alarms
MAJ MIN WRN
0 0 0




DSP Channel Status
DSP 1: in-service/active, 2 calls
DSP 3: in-service/active, 1 calls
DSP 5: in-service/active, 2 calls
DSP 7: in-service/active, 2 calls

************************************************************
I ve got 7 medpro located in three PN but in everycard
I only see port 1,3,5,7

I checked another customer of ours and there it shows :

01B04 IP MEDIA PROCESSOR TN2302AP HW21 FW110 01 02 03 04 05 06 07 08

Any ideas?

 

[Mitch672]

This is how the TN2302AP shows up because of it's hardware design, this is normal as each DSP supports 8 or 16 channels, depending upon what codec is used (G711 uses 1 channel per call, G729 or other compressed codecs use 2 per call).

AVAYA has an explanation of this on the support website that I have seen before.

mitch


AVAYA Certified Specialist