Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Medpro DSP resources on "odd" channels only

Status
Not open for further replies.
jtierney

jtierney

Vendor
Joined
Sep 29, 2003
Messages
126
Location
US
We have a location on CM 4.1 with tn2302 h21 fw117 boards where the "status media-processor board xxxxx" shows only channels 1,3,5,7 in use and does not even show the 2,4,6,8 channels. The medpros in all 2 PN's are doing this.

Users are complaining of dropped calls.
Thoughts?

JT
 
Sort by date Sort by votes
Since CM 4.0, all of the TN2302AP MEDPROs only show the 4 channels 1 3 5 7.. I don't think this is a problem. This is just how it is with CM 4.0 or above... I would look at your Duplex and Speed for your MEDPRO's, and make sure you lock both the cards and ethernet switch ports to 100MB/Full.

Mitch
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

letman2
  • Locked
  • Question Question
remove medpro and clan boards
Replies
4
Views
546
letman2
letman2
MIKEY-MIKE7
  • Locked
  • Question Question
AVAYA DEFINITY "AUDIX" TN 568 PROBLEM
Replies
1
Views
493
phoneguy55
phoneguy55
Richard_Harrow
  • Locked
  • Question Question
Both security modules of session managers are showing as "down" after changing the time on
Replies
6
Views
760
mattKnight
mattKnight
homemade88
  • Locked
  • Question Question
"Unrecoverable processing error occurred" When Loging Into SMI
Replies
6
Views
896
homemade88
homemade88
Craft01
  • Locked
  • Question Question
Removing patch Status stuck at "deactivating"
Replies
3
Views
593
JefferP
JefferP

Part and Inventory Search

Sponsor

Back
Top