MD110BC12SP7-AXE10

[trond345]

Hi, I'm trying to connect MD110BC12sp7 to the AXE10 public switch through ISDN PRI.
CNLIP.. says that the TLU6/1 is active
SUSIP for that route says that these channles are free

My parameters
ROCAP:ROU=1;
SEL=7130000000000010,traf=00151515,trm=4,serv=2110000010,
sig=411110000030.
Rodap:rou=1;
varc=00000310
vari=15400000
varo=06410000
the case is that MD110 users when dial(9) which is the access code of this route they cant hear dial tone and can't make a call,even if I type the command CTDEI when trying to make an out going using these trunks the printout says no connection!!

Is there any advice to change my parameters (ROCAI,RODAI)? Is there any recomended ones?If yes please help.

 

[HIREI]

Hi,
I gave you examle once:

http://www.tek-tips.com/viewthread.cfm?qid=1168481

It isn't enough? Don't work? But it is for ETSI PRI.

 

[whosrdaddy]

trond345,

make a trace on SLP60, this way you'll see what the problem is...

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[trond345]

Hirei:
Thanks but I tried the same parameters in the example you gave me before and it is the same problem (doesn't work)! I'm trying to connect ISDN PRI to AXE10 (GSM operator). are u experienced with such example before.
Regards.

 

[slash50]

Do you have any least cost routing that could be sending the calls a different way?

 

[whosrdaddy]

IMHO, config is OK, make a TRACE :

STISR;
STUNI:UNIT=SLP60,MSKSIG=02&03&A1,STORE=YES,LIM=X;
STTSI:TRI=1;
/* make call
STTSE:TRI=1;
/* open log file
STRAP:TRI=1;

X is the lim where the trunks are (ROEDP)...

paste results here with mono text tags:
[ignore][tt] your trace text[/tt][/ignore]

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[HIREI]

to trond345:

yes, of course, this connection is in operation. AXE-10 is wireline, and MD110 is BC9 CNI76.

 

[HIREI]

And, may be AXE specialists will do a trace for you when you trying to call?

 

[trond345]

Thank guys,, your parameters are right... it was a miss configuration from AXE10 specialists