Maxing at 230kbps on full T1.

[TravisM]

We have 5 sites, two with Cisco 1005's, 1 2501, one with a 3620, and a central site that all these routers are connected to a Cisco 3640.

Each site is connected to the central site with a full Point to Point T1, but even when moving large files, and trying to max out the bandwith, the routers are only hitting around 230 kbps. In the case of the 1005's I could chalk it up to them being older routers, but this seems to be happening even out to the site with the 3620.

The 3620 and 3640 both have have internal CSU/DCU wic cards, while the other three routers are connected with Adtran devices. As far as I know, all of the interfaces are configured correctly... Any ideas where I should look to find out why my bandwith is so limited?

Thanks in advance!

-Travis.

 

[baddos]

Is the T1 at the main site channelized?

 

[TravisM]

No. Each T1 is on an individual circuit. All of the interfaces are relatvely error free also. There are some random input errors, but they're very infrequent...

-Travis.

 

[JGranieri]

Travis,

Do you habe anu rate-limit commands in any of your configs. What is the number of T1 channels your router is configured for??

Make sure your TELCO provider and your circuit are on the same page? What is the rate/speed they assigned to you..

Jeff

 

[TravisM]

Jeff,

No rate limit commands on any of the configs. =/ As far as the number of channels it's configed for, I didn't make any specific settings on the service modules. Maybe this is the problem? I may be a little confused on this item, would I set this in the interface with the service-module t1 timeslots command?

The TELCO, Qwest, has all of the circuits apportioned as full T1's.

-Travis.