LSP

[mrjedi]

I have been trying to find the timer for a gateway to switch to LSP. I want to increase the timer as we are getting a lot of network hits. Can someone tell me how to change the timer.

 

[dmoore7648]

I don't think you can. We wanted to decrease the time and we were told it was fixed.

 

[mrjedi]

dmore7648

Here's what I found out. It may be of interest to you.

1. At the MG-001-1(configure)# prompt, type set mgp reset-times primary-search <search-time>
where <search-time> is the time in minutes that the G700 searches for a primary controller before looking for an LSP. The range is from 1 to 60.
2. At the MG-001-1(configure)# prompt, type set mgp reset-times total-search <search-time>
where <search-time> is the time in minutes that the G700 searches for both primary controllers or LSPs. The range is from 1 to 60.
3. At the MG-001-1(configure)# prompt, type set mgp reset-times transition-point <#_of_primary>
where <#_of_primary> is the number of primary controllers in the controller list. If the primary controller is an S8700, the range is from 1 to 4. If the primary controller is an S8300, <#_of_primary> must be 1.

 

[shoreguy]

Use the "change system-para ip-options" at the bottom of the page is a field called "link loss delay". By default this field is set to 5 min, you can change this field to something between 1-30 to help control linl bounce