LSP Mode

[chuck14]

I am configuring a S8300 w/G700 and I have it up and running. However when I disconnect the network link to the wan the S8300 will not go into LSP mode. What am I missing?????

Thanks for your help.

 

[uzumaki]

What release do u have? Some releases have this issue. Do u have the patch on this?

Thanks.

 

[ken07734]

have you verified the correct ip addresses in the MGC list of the media gateway?

 

[chuck14]

we are installing cm 3.1.4. yes the mgc is showing the clan of the s8710 and the local gw.

 

[jconrad0305]

did this ever get fixed. i am having the same issue with an 8300 and g350. it will like to the clan at the main site fine but will not register to the 8300. i did the show mgc and it is

192.168.200.3 (clan at main site)
192.168.101.10 (8300 LSP)

the recover transition stuff is
5
20
1 transition point

ACA & ACS IPO Implementation
ACA IP Telephony

 

[definityandcmuk]

how long are you waiting? It may take a few minutes

also do "list survivable" from the main server and see if the LSP is registered and translations are updating

from the MGP do a list mgc, see if the LSP address is in the list

 

[definityandcmuk]

The primary seach time of"5" means it will search for 5 minutes before entering LSP mode, I would set this to 1 minute

 

[jconrad0305]

the lsp is registered at the main site. i will change the 5 to 1 tomorrow when i go on site. i will also check the translation update. i guess the customer was changing route options and other stuff like that so the lsp never got the trans.

ACA & ACS IPO Implementation
ACA IP Telephony