a lotus 123 file running off a network server, shared between multiple users, when they try and use the Find and Replace feature it causes an error message that the instruction at 0x7801151b referenced memory at 0x00000000 the memory could not be read, then the program closes if you press either ok or cancel on the message box. any suggestions?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Lotus 123 tool box error message
- Thread starter btap
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question