Location of forms at startup

[pierrotsc]

is it possible to setup the exact location of a form on a screen at startup?
For example, i need to check that the user has at least a 1024x768 resolution, then i have 2 forms that display when the program starts. right now one form is on top of the other. i would like to have a set location for both forms.
Thanks.
PO

 

[Glenn9999]

Form.Height
Form.Width
Form.Left
Form.Top

 

[CADTenchy]

You may also find some of the replies on the following thread of use.

http://www.tek-tips.com/viewthread.cfm?qid=1436729&page=1

 

[DelphiAaron]

You check the screen res with screen.width and screen.height.

You can even do this in the project source before the forms are created.

begin
  Application.Initialize;
  if screen.Width < 1024 then exit;
  Application.CreateForm(TForm1, Form1);
  Application.Run;
end.

Look at the forms position property in the object inspector to set the forms position at runtime.

Aaron

 

[pierrotsc]

Thanks guys...this is what i needed to know...
po