Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

LMI Help Needed

Status
Not open for further replies.

spearce02

Technical User
Dec 15, 2004
26
US
I have a Option 11c with 2 remote locations, 1 of these locations has 2 T1's to connect it back to the main office with 6 Digital Line Cards and 2 Analog Cards, I am trying to move 3 of these Digital Line Cards and 1 analog card to a new location using 1 of the T1's that was previously used in the old location, I have all the parts and have installed everything including swapping one of the LMX cards with a LMI so I now have a LMI,LMX,LMI,LMX setup in one of the cabinents at the main office, I have all switch settings correct and card configurations but cannot get them to link up and get dial tone, I know this is lenghty but any suggestions would be helpful.
 
no reason this can't work, were's it broke at? once we answer that you finished.. put a loop on the remote end to see if you can loop back to the switch. if not put a loop on local for the same test. 1st make sure that the hardware and the t1 is good.. if all the cable numbers are right then go from their. had one a few years back in trouble on a new install. drove to the far end, conld not loop. took the cab back and connected it local. found the bad card, brought it up using a patch for the t1. took it back across town, still wouldn't come up. turned out the t was ami, although we has requested b8zs esf.. two problems, by moving the cab, fixed them one at a time

john poole
bellsouth business
columbia,sc
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top