List of emailed system alarms? 1

[Ragnorak]

On the System > System Alarm tab you can set the system to email you various alarms.

I would like to set up inbox rules to seperate them into various folders. Is there a list of the alarms and how they show up in email published anyplace? Thanks.

 

[sizbut]

The bits in "quote marks" are the email messages. The subject takes the form '<system name>:<IP address> - System Alarm'.

Entity - Application
====================
1) Voicemail operation
"The Voicemail server is now operational."

2) Voicemail Failure
"The Voicemail server is down."

3) Voicemail Event - storage OK
"The Voicemail server storage is OK."

4) Voicemail Event - storage nearly full
"The Voicemail server storage is nearly full."

5) Voicemail Event - storage full
"The Voicemail server storage is full."

6) Delta Server Operational
"The Delta server is now operational."

7) Delta Server Failure
"The Delta server is down."


Entity - Compact Flash Card
===========================
1) Change
"The PC card in name has changed."


Entity - Expansion Module
=========================
1) Operational
"Expansion module name link is up."

2) Failure
"Expansion module name link is down."

3) Error
"Expansion module name link has a link error."

4) Change
"Expansion module name link has changed."


Entity - Trunk
==============
1) Operational
"Trunk n (name) [on expansion module n] is now operational."

2) Failure
"Trunk n (name) [on expansion module n] is down."


Entity - VCM
============
1) Operational
"VCM module name is now operational."

2) Failure
"VCM module name has failed."


Generic - Generic
=================
1) Network link failure
"Network Interface name (ip address) has been disconnected."

2) Network link operational
"Network Interface name (ip address) has been connected."

3) System warm start
"System has been restarted (warm start)."

4) System cold start
"System has restarted from power fail (cold start)."

5) SNMP Invalid community
"Invalid community specified in SNMP request."


Licence - Licence
=================
1) Server operational
"The license server is now operational."

2) Server failure
"The license server is no longer operational."


Loopback - Loopback
===================
1) Near end line loopback
"Trunk n (name) [on expansion module n] is in near end loopback."

2) Near end payload loopback
"Trunk n (name) [on expansion module n] is in near end loopback with payload."

3) Loopback off
"Trunk n (name) [on expansion module n] has no loopback."


Phone Change - Phone Change
===========================
1) Phone has been unplugged
"The phone with id n has been removed from extension extn (unit, port n)."

2) Phone has been plugged in
"The phone with type type (id n) has been plugged in for extension extn (unit, port n)."

 

[Ragnorak]

Awesome. Thank you.

Will the trunk alarms work for POTS lines or just T1/PRI/BRI?

 

[sizbut]

Sadly SNMP doesn't cover analog trunks, Modem cards and WAN3.

Not surprising on analog trunks, they don't provide much in the way of signalling when idle.