List dissabled Line Side T1 Cards

[hayniematt]

I have a Line Side T1 card that I'm not getting a signal from and suspect that it has been dissabled since it hasn't been used in a while. Unfortunately I don't know how to address a line side t1 card. I know where the card is physically in the switch and I believe when I know the address I can just use the following command to enable it:
ld 20
>enlu xx xx xx
where the xx's are the TN for the card

I tried "luc" and got a fat list of cards, would any of those be listed if they were just dissabled?

I also looked at my history files and found some TN's that I believe get dissabled when they are not in use:
% NWS301 4 0 : -1 -2 -3 -4 -5 -6*
% NWS301 20 0 : -8 -9 -10*
% NWS301 24 0 : -0 -1 -2*
% NWS401 36 0 2 : -2 -4 -10 -11 -12 -13 -15
% NWS501 40 0 12 : -15
% NWS501 56 0 0 : -13
% NWS501 64 0 11 : -13
% NWS501 68 0 0 : -7
% NWS501 80 0 4 : -3
I tried enalbing the ones with a * at the end since they are the only ones that don't specify a single line. No luck.

 

[hayniematt]

I figured out what the address's are for the cards I have by looking at the labels. Now I just need to figure out why 2 of the 5 cards have lights on for "red alarm".

 

[Johnthephoneguy]

YOu can stat them in 20 to see if they are disabled or not

 

[johnpoole]

enlc x x x for a card enlu x x x x for a set. line sides are tough, you can't see the far in, analog. i have numbers on my line side that are on either fax machines or modems so if i have a question about status, i can call the number to test for answer supervision

john poole
bellsouth business
columbia,sc