Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Linking two Cisco 2950 together
- Thread starter epsilon6
- Start date
This is true if you're using the default configuration.
If you want to carry traffics from more than 1 VLAN than you need to set ISL/802.1q switchport trunking.
If you want to use multiple linkages between the 2 switches than you need to set FastEtherChannel.
If you want to carry traffics from more than 1 VLAN than you need to set ISL/802.1q switchport trunking.
If you want to use multiple linkages between the 2 switches than you need to set FastEtherChannel.
robertjo24
MIS
The 2950's should default to 801.Q trunking, and auto trunk on ports between the two switches.
If you are running between GBIC's, I doubt you would need to set FastEtherChannel.
The Cisco site has pretty good information on setting up VLANs on the 2950's, but don't hesitate to ask if you get stuck.
Jerry "O
If you are running between GBIC's, I doubt you would need to set FastEtherChannel.
The Cisco site has pretty good information on setting up VLANs on the 2950's, but don't hesitate to ask if you get stuck.
Jerry "O
- Status
