Supportvzla
Technical User
Good morning, we are establishing a link between two switches SIP CS1000 Rls 7.5, in both pbx were the settings required in the documentation, the current status is that in both pbx register the local endpoint but not remote and therefore not binding up.
In both pbx is programmed PBX IP phone at the other end and it works normally.
They can help to verify if need some tips to lift the link, a port that needs to be open especially in the network, etc.
Your help is invaluable.
regard
In both pbx is programmed PBX IP phone at the other end and it works normally.
They can help to verify if need some tips to lift the link, a port that needs to be open especially in the network, etc.
Your help is invaluable.
regard
