LDK100 PRIB CONECTOR PINOUT

[JuliusDM]

Hello Sirs,

can you share the pin-out for the LDK-100-Mcr-PRIB board connector?

my best wishes for all of you.


Julio Mx

 

[doktor]

PIN TE (terminal side)
1 Receive
2 Receive
3 Shield(R) *
4 Transmit
5 Transmit
6 Shield(T) *
7 Power Source *
8 Power Source *
---------------------
PIN NT(net side)
1 Transmit
2 Transmit
3 Shield(T) *
4 Receive
5 Receive
6 Shield(R) *
7 Power Source *
8 Power Source *



///doktor

http://www.kandu.dk/spg153996.aspx

 

[JuliusDM]

Hello Doktor

Gracias for the pinout


Julius

 

[JuliusDM]

Hello Doktor,

Thanks again for the pinout, now we have the link up (back to back) between the LDK PRIB Card and an Avaya PBX (DS1 card).
after some difficulties about the protocol were solved now the d-channel is up with ETSI protocol and the Avaya phones can place calls to LG phone fine, but LG phones viceverza can not (get busy tone after 4th digit is dialed)
Avaya has the series 70xx, 71xx, 75xx and LG has the serie 99xx
Im not the LG guy, but the real LG guy is kind of newbie and have no more ideas.
I was wondering if you can help me with this issue, if so, pls tell which printout from the LDK to post it here.

Regards

Julio

 

[doktor]

Your LG guy must check the PGM 107,108 and 109 - and change all 7 xxx number ( at least the 70xx, 71xx, 75xx numbers). Hereafter make 7 as prefix for the PRIB line.
If all calls should go to the AVAYA you couls also press 9 (or 0) and then 70xx, 71xx, 75xx.

Let me know your status & update.

///doktor

http://www.kandu.dk/spg153996.aspx