Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
LDK100 - has defaulted to its factory settings
- Thread starter philzi
- Start date
Not 100% sure, but it could be a dead battery on the MPB, or a failing MPB.
Factory settings can be restored if DIP 8 (from memory I think it is DIP 8) is toggled on and the system restarted, or someone on the system entered ADMIN Programming and used PGM 450 INITIALIZATION and chose to wipe the system.
I had an LDK-20 system and it defaulted to its factory defaults in Korean when the 1/2 AA battery went flat on it. Had to replace the battery in it to get it working again, otherwise it would forget everything when the power went out!
Factory settings can be restored if DIP 8 (from memory I think it is DIP 8) is toggled on and the system restarted, or someone on the system entered ADMIN Programming and used PGM 450 INITIALIZATION and chose to wipe the system.
I had an LDK-20 system and it defaulted to its factory defaults in Korean when the 1/2 AA battery went flat on it. Had to replace the battery in it to get it working again, otherwise it would forget everything when the power went out!
- Thread starter
- #3
montyzummer
IS-IT--Management
someone has done pgm450 , the battery has run out after a long power cut , it will recharge on this model , if the site deny a power failure if you connect to the serial port 19200 ,8 ,1 none 9wayD type rs232 lead straight through ,think its only pins 2,3,5 but to be sure just connect all then plug in reboot , get into brandy and do some digging , also check the actual battery switch is turned on alongside dipswitch 8 .
password
brandy... yip like the drink ... hit the help menu by pressing ? , and you will find information about shutdown and boot up times i cant remember the exact location but its sure there as i have had to prove customers lie when the kit dies as they have no ups , rubbish power and then dont want to pay for a visist
APSS (SME)
ACSS (SME)
ACIS (UC)
password
brandy... yip like the drink ... hit the help menu by pressing ? , and you will find information about shutdown and boot up times i cant remember the exact location but its sure there as i have had to prove customers lie when the kit dies as they have no ups , rubbish power and then dont want to pay for a visist
APSS (SME)
ACSS (SME)
ACIS (UC)
- Status